|
- 22.5° angle side.
- 11.25° angle side.
- 90° angle side.
THE ANGLES MAKE ALL THE DIFFERENCE! 11.25°, 22.5°, 90° These 3 angles are specifically designed for HVAC installation! They are all you need to create any complex fitting
- Rulers on both exterior sides, eliminating the need for an additional ruler.
|
(Click Image to Enlarge) |
- Quick measurement table for 3 & 5 piece elbows with varying throat sizes. By using the table, you can cut any size throat 90° elbow you require because the math has already been figured out for you. First decide where you want the elbow to start. Then determine the throat size and reference the table for proper diagonal cut measurements.
- Quick measurement table for risers and offsets. You can create 3 piece or multiple piece fittings with either a gradual 22.5 degree slope or a sharp 45 degree slope. Just determine the offset and reference the table for proper measurements between the parallel diagonal cuts.
- A duct board scale on the bottom of the tool, in increments of 47 inch duct sections. Four most commonly used scales; 3/16", 1/8", 1/4", 3/8".
|
(Click Image to Enlarge) |
|
|
 |
